с тремя дисками по 750Гб.
В биосе рейд отключен, диски нужны по одиночке. Встала ОСь нормально, однако подмонтировать остальные два
винта не дала в процессе установки.
Думал замаунтить их потом, но оказалось, это не такая уж и тривиальная задача...
Разделы создавать я на них могу, ext2 (кроме нее при установке ничего не хотело вставать) монтируется (потом другие уже и не пробовал, она устраивает).
Код: Выделить всё
#mount /dev/sdb1 /mnt/doc1
#mount: unknown filesystem type 'ddf_raid_member'
#mount /dev/sdb1 /mnt/doc1 -t ext2
#mount: /dev/sdb1 already mounted or /mnt/doc1 busy
#lsof /dev/sdb1
#
# mount
/dev/sda1 on / type ext3 (rw,errors=remount-ro)
tmpfs on /lib/init/rw type tmpfs (rw,nosuid,mode=0755)
proc on /proc type proc (rw,noexec,nosuid,nodev)
sysfs on /sys type sysfs (rw,noexec,nosuid,nodev)
udev on /dev type tmpfs (rw,mode=0755)
tmpfs on /dev/shm type tmpfs (rw,nosuid,nodev)
devpts on /dev/pts type devpts (rw,noexec,nosuid,gid=5,mode=620)
/dev/sda9 on /home type ext3 (rw)
/dev/sda8 on /tmp type ext3 (rw)
/dev/sda5 on /usr type ext3 (rw)
/dev/sda6 on /var type ext3 (rw)
#
# fdisk -l
Disk /dev/sda: 750.2 GB, 750156374016 bytes
255 heads, 63 sectors/track, 91201 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0x000645e7
Device Boot Start End Blocks Id System
/dev/sda1 * 1 43 340992 83 Linux
Partition 1 does not end on cylinder boundary.
/dev/sda2 43 91202 732230657 5 Extended
/dev/sda5 43 1137 8787968 83 Linux
/dev/sda6 1137 1502 2928640 83 Linux
/dev/sda7 1502 3496 16012288 82 Linux swap / Solaris
/dev/sda8 3496 3544 389120 83 Linux
/dev/sda9 3544 91202 704108544 83 Linux
Disk /dev/sdb: 750.2 GB, 750156374016 bytes
81 heads, 63 sectors/track, 287115 cylinders
Units = cylinders of 5103 * 512 = 2612736 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0xed598ccf
Device Boot Start End Blocks Id System
/dev/sdb1 1 287116 732573560 83 Linux
Disk /dev/sdc: 750.2 GB, 750156374016 bytes
81 heads, 63 sectors/track, 287115 cylinders
Units = cylinders of 5103 * 512 = 2612736 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0x976230a1
Device Boot Start End Blocks Id System
/dev/sdc1 1 287116 732573560 83 Linux
#
# dmesg | tail -n20
[ 8.471528] EXT3-fs: mounted filesystem with ordered data mode.
[ 10.514623] alloc irq_desc for 28 on node -1
[ 10.514626] alloc kstat_irqs on node -1
[ 10.514638] tg3 0000:02:00.0: irq 28 for MSI/MSI-X
[ 10.548666] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 12.111160] tg3: eth0: Link is up at 100 Mbps, full duplex.
[ 12.111162] tg3: eth0: Flow control is on for TX and on for RX.
[ 12.112011] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 23.092004] eth0: no IPv6 routers present
[ 7314.240334] sdc: sdc1
[ 7613.809377] sdb: sdb1
[ 9968.488560] tg3: eth0: Link is down.
[ 9973.195963] tg3: eth0: Link is up at 100 Mbps, full duplex.
[ 9973.195964] tg3: eth0: Flow control is on for TX and on for RX.
[ 9976.761158] tg3: eth0: Link is down.
[ 9978.962813] tg3: eth0: Link is up at 100 Mbps, full duplex.
[ 9978.962815] tg3: eth0: Flow control is on for TX and on for RX.
[ 9994.264892] tg3: eth0: Link is down.
[ 9995.866626] tg3: eth0: Link is up at 100 Mbps, full duplex.
[ 9995.866627] tg3: eth0: Flow control is on for TX and on for RX.
#Если отбросить варианты перепрошивки мозгов контроллера, есть варианты?
