ATI Radeon 9600 PRO... пытаюсь настроить тв-выход...
до старта иксов все нормально... как только стартует икс-сервер - все на телевизоре превращается в рябь...
xorg.conf:
Section "Monitor"
Identifier "monitor1"
VendorName "LG"
ModelName "L1950SQ"
HorizSync 30-65
VertRefresh 50-70
EndSection
Section "Monitor"
Identifier "monitor0"
VendorName "LG"
ModelName "TV"
HorizSync 30-40
VertRefresh 60
EndSection
Section "Device"
Identifier "device1"
VendorName "ATI"
BoardName "ATI Radeon (fglrx)"
Driver "ati"
Option "DPMS"
EndSection
Section "Device"
Identifier "device0"
VendorName "ATI"
BoardName "ATI Radeon (fglrx)"
Driver "ati"
Option "DPMS"
# TV-out
Option "IgnoreEDID" "true"
Option "TVStandard" "PAL"
Option "ConnectedMonitor" "TV"
Option "TVOutFormat" "COMPOSITE"
EndSection
Section "Screen"
Identifier "screen1"
Device "device1"
Monitor "monitor1"
DefaultColorDepth 24
Subsection "Display"
Depth 8
Virtual 1280 1024
EndSubsection
Subsection "Display"
Depth 15
Virtual 1280 1024
EndSubsection
Subsection "Display"
Depth 16
Virtual 1280 1024
EndSubsection
Subsection "Display"
Depth 24
Virtual 1280 1024
EndSubsection
EndSection
Section "Screen"
Identifier "screen0"
Device "device0"
Monitor "monitor0"
DefaultColorDepth 24
Subsection "Display"
Depth 24
Modes "800x600"
EndSubsection
EndSection
поставил atitvouot:
# atitvout vbe
VBE Version: 2.0
VBE OEM Identification: ATI RADEON 9600 PRO
# atitvout tvout
VBE call failed.
Maybe this command is not supported by your graphics adapter?
Did your parameters (if you specified some) really make sense?
Please try all other available commands before complaining!
# atitvout standard
Can set on the fly:
ntsc
pal
Current standard is PAL.
# atitvout detect
CRT is attached.
TV is attached via S-Video.
мыслей нет никаких...
по гуглю полазил перепробовал различные варианты (различные это всего три, которые я нашел для ATI)... ничего не помогает... может не там искал?