akira:~# dmesg | grep saa
saa7130/34: v4l2 driver version 0.2.14 loaded
saa7134[0]: found at 0000:05:02.0, rev: 1, irq: 19, latency: 64, mmio: 0xff9efc00
saa7134[0]: subsystem: 1461:9715, board: Avermedia AVerTV Studio 307 [card=45,autodetected]
saa7134[0]: board init: gpio is 3b8
input: saa7134 IR (Avermedia AVerTV St as /class/input/input2
i2c-adapter i2c-0: adapter [saa7134[0]] registered
saa7134[0]: i2c eeprom 00: 61 14 15 97 ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: registered device video0 [v4l2]
saa7134[0]: registered device vbi0
saa7134[0]: registered device radio0
i2c-core: driver [saa6752hs] registered
tuner 0-0043: chip found @ 0x86 (saa7134[0])
tuner 0-0061: chip found @ 0xc2 (saa7134[0])
i2c-dev: adapter [saa7134[0]] registered as minor 0
saa7134 ALSA driver for DMA sound loaded
saa7134[0]/alsa: saa7134[0] at 0xff9efc00 irq 19 registered as card -1
akira:~# v4l-conf
v4l-conf: using X11 display :0.0
dga: version 2.0
WARNING: No DGA support available for this display.
mode: 1600x1200, depth=24, bpp=32, bpl=6400, base=unknown
WARNING: couldn't find framebuffer base address, try manual
configuration ("v4l-conf -a <addr>")
/dev/video0 [v4l2]: configuration done
При запуске тв имеем:
akira:~# xawtv
This is xawtv-3.95.dfsg.1, running on Linux/i686 (2.6.23.8)
WARNING: No DGA support available for this display.
WARNING: couldn't find framebuffer base address, try manual
configuration ("v4l-conf -a <addr>")
akira:~# tvtime
Running tvtime 1.0.2.
Reading configuration from /etc/tvtime/tvtime.xml
Reading configuration from /root/.tvtime/tvtime.xml
xvoutput: No XVIDEO port found which supports YUY2 images.
*** tvtime requires hardware YUY2 overlay support from your video card
*** driver. If you are using an older NVIDIA card (TNT2), then
*** this capability is only available with their binary drivers.
*** For some ATI cards, this feature may be found in the experimental
*** GATOS drivers: http://gatos.souceforge.net/
*** If unsure, please check with your distribution to see if your
*** X driver supports hardware overlay surfaces.
Вроде все стоит... кроме DGA и framebuffer не находит
Можно вручную, но v4l-conf -a "framebuffer" - что указывать?в xorg прописано
SubSection "extmod"
Option "omit xfree86-dga"
EndSubSection
Не дайте помереть, оч хоцца телек посмотреть и радио послушать.