dmesg | grep eth0
[ 30.873046] e100: eth0: e100_probe: addr 0xfb000000, irq 20, MAC addr 00:16:e6:58:18:7b
[ 49.630328] e100: eth0: e100_watchdog: link up, 100Mbps, full-duplex
[ 75.430792] eth0: no IPv6 routers present
ifconfig
eth0 Link encap:Ethernet HWaddr 00:16:e6:58:18:7b
inet6 addr: fe80::216:e6ff:fe58:187b/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:468 (468.0 B)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1706 errors:0 dropped:0 overruns:0 frame:0
TX packets:1706 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:85300 (83.3 KB) TX bytes:85300 (83.3 KB)
и после
dmesg | tail
[ 53.145471] agpgart: Found an AGP 3.0 compliant device at 0000:00:00.0.
[ 53.145503] agpgart: Putting AGP V3 device at 0000:00:00.0 into 8x mode
[ 53.145545] agpgart: Putting AGP V3 device at 0000:01:00.0 into 8x mode
[ 53.412629] [drm] Setting GART location based on new memory map
[ 53.412650] [drm] Loading R300 Microcode
[ 53.412701] [drm] writeback test succeeded in 1 usecs
[ 64.936154] NET: Registered protocol family 10
[ 64.938136] lo: Disabled Privacy Extensions
[ 75.430792] eth0: no IPv6 routers present
[ 273.641643] NET: Registered protocol family 17